On most Asian pianos pedal Pivot Pin is made out of brass,knurled part gets worn out,pin rotates and sqeaks. Solution: 1-2 years ago there was a technical tip I submitted to the Journal ,full description is there. Drill and tap hole trough the top of the pedal and 2 sets screws {6/32"] will secure the pin.Do it to all 3 pedals.It doesn't take too long ,providing you have all the drills and taps in one plastic box as a Kit for that operation. Brass drills and taps easely.This method helps to install pedals in Verticals without removing the Bottom Board. Hope it helps.. Isaac -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20060706/aff481be/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC