I just put a metal-cutting blade on my bandsaw. Cuts like butter.... Terry Farrell ----- Original Message ----- > Get mine from a machine shop. 1 1/2" brass rod, cut to various lengths > from about 3/4 of an inch up to 1 1/4 long. It's worth whatever he's > charging me for him to cut it, y'know. His rates are lower than > mine......... > > Later, > Guy > > > At 06:42 PM 1/30/2006 -0600, you wrote: > I'm finally getting around to working on the piano which had a boomy > crossover from the long bridge to the bass bridge. I'm envisioning > getting some rolled brass stock and cutting off pieces for this. I've cut > aluminum with a carbide blade, I think brass might be a little harder. > How difficult is this to do? I'd drill a screw hole in the center and > temporarily set under the bridge until I get the impedance I want. > >>How do you pro's do this? Where do you source your material and what is >>your favorite means of machining it? >> >>Andrew Anderson
This PTG archive page provided courtesy of Moy Piano Service, LLC