trouble removing the plate

[Lhadeh at wmconnect.com]

I had trouble removing the plate from a Mason & Hamlin upright too.  The 
right key bed support had to have a notch made to get at one screw.   Even though 
it had five or six screws into the side of the piano case, it was also glued.

Then when the plate was loose, it still couldn't be removed due to a piece of 
walnut moulding glued to the case top that was wider than the top to hide the 
top edge of the plate casting.  I damaged the moulding trying to remove it, 
so will have to cut a new one when it goes back together.

It was obvious this piano case was built up after the sound board and plate 
were attached with little consideration to future disassembly for rebuilding.  
Planned obsolesence?

Loren Hedahl


-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20060407/ba2a714e/attachment.html