But I thought it was a slow removal like this that created the heat that we don't want????? Avery At 03:41 PM 9/5/05, you wrote: > Hello List >Terry Peterson asked: > > >I also would like to get opinions as to how fast, slow to remove them to >avoid over->heating and/or scortching the pin block. I know the pins WILL >get hot no matter what, (I tested this by using the very lowest rpm possible >without stalling) but it seems to me that the main thing to avoid is >"spinning" the pin in place when/if it stops rising outward during removal. >I try to use lowest rpms to remove each pin, then releasing trigger when >it's almost out, letting the drill slow to a stop at which point the pin >drops out...ideally. thoughts? > >This is how I do it. I know it takes a long time and plenty of mugs of tea >to replace the lost body fluids but..... Restringing takes a long time and >the end result is all-important. Why use valuable electricity and spend >money on expensive electric drills with a reverse when a simple hand-brace >(such as illustrated) will do the same thing at the right speed, infinitely >controllable ...... >NOW... Will this Posting get through with its attachments without being >considered "suspicious"? > >Regards from a dark night on the Sussex Downs >Michael G.(UK) > >Download Photoshop(R) Album 2.0 Starter Edition free to create your own >photo slideshows! >http://www.adobe.com/getstarteredition > > >_______________________________________________ >pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC