Upright hammer shanks

[Farrell]

First set of hammers I ever installed were on an old upright and I used the 
Spurlock method and hammer-hanging jig. Damn, did they look nice! Perfect 
job (and it had very little to do with me - except that I used the right 
jigs and instructions).

Terry Farrell

----- Original Message ----- 
> If they are the old cedar shanks they might very well be nearing the 
> usefulness...Bill Spurlock has a good system for upright hammer 
> installation...in fact I have the stuff if you want to use it....of course 
> I'd have to find it.   Pre-hang the hammers on the shanks, I believe...
>
> David Ilvedson, RPT
> Pacifica, California