While I've never been a proponent of using fiberglass resin or epoxy to mate a pinblock to the plate flange I'm wondering, if because of the exigencies of circumstances I had to go this route, what are you all using...material wise, to do this? Brand names, success rate, viscosity, etc. BTW, to the very few of you who responded to my last query re the removal of recently installed plastic key tops, thanks much...the dry heat from an old cloths iron or a heat gun did the trick Paul E. Dempsey, RPT Piano Technician Sr. Marshall University Huntington, WV 304-696-5418 304-617-1149
This PTG archive page provided courtesy of Moy Piano Service, LLC