This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Hello Matthew and List I usually raise the nameboard by inserting pieces of felt under the ends. Sometimes I use cloth balance punchings and screw through the hole. Of course you can only do this if the fall rail or the top panel isn't impeded thereby. :-) Regards Michael G.(UK) _____ From: Alan Barnard [mailto:tune4u@earthlink.net] Sent: 05 October 2005 20:47 To: Pianotech Subject: RE: Keytop trimmin' As the the fronts, just use a flat file to trim them flush. Or, if you're a little braver and want to speed it up, use a Dremmel with a sanding wheel. Or start with the Dremmel and do final trim with the file. Or train gerbils to knaw off the excess. Your choice. As to the tails: You WANT the plastic to go far enough under the fallboard felt so that no wood shows. You have to trim the plastic flush with the sides of the key, of course. If key thickness is the problem, then I ask, "Did you sand/plane the keytops down so the overall dimension with the new tops is the same?" Or, I might ask, "Can you shim or otherwise adjust the fallboard up a tad?" Or, I might ask, "Why do cannibals refuse to eat clowns?" You don't need a lot of clearance between the key and the nameboard felt. (?) Maybe you can clarify the problem for us .... Alan Barnard Salem, Missouri ----- Original Message ----- From: Matthew <mailto:toddpianoworks@yahoo.com> Todd To: Pianotech <mailto:pianotech@ptg.org> Sent: 10/05/2005 3:29:39 PM Subject: Keytop trimmin' Hey guys, I am in the middle of my third keytop replacement job. As it turns out, the tails of the tops are about a 1/4'' too long. If I put them on, they will probably get in the way of the fallboard. Is there a way to cut the tail length?? And the keytop front goes down past the key quite a bit too. Matthew _____ Yahoo! for Good Click here to donate <http://store.yahoo.com/redcross-donate3/> to the Hurricane Katrina relief effort. ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/aa/85/de/ad/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC