Would you be able to lower the pitch by grinding from the middle, as in a glockenspiel bar? - Rick Barber > Hi Rick: > I have had experience with Schoenhut's baby grand toy piano. It > uses a > row of hardened steel rods attached to a frame. The hammers strike > each rod > creating a tone. To tune (I used an accutuner), raise the pitch of a > note > by grinding a bit of metal off the end of the rod. To lower the > pitch, > solder a bit of solder to the end. Schoenhut still has parts for these > toys, I used a new set of rods which were woefully out of tune. > Mike Kurta
This PTG archive page provided courtesy of Moy Piano Service, LLC