This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Thanks for the help, and the tips, everyone. Fortunately there's a = Harbor Freight not too far from me.=20 =20 -----Original Message----- From: pianotech-bounces@ptg.org [mailto:pianotech-bounces@ptg.org] On = Behalf Of Joe Garrett Sent: Friday, July 22, 2005 4:52 PM To: pianotech Subject: Re: Yamaha repetition lever adjusting screw question Geoff asked: "I can't find that felt punching in the catalog so I don't quite know what = =3D to ask for. So, today's questions are... =3D20 : Is that felt punching the same as a thin balance rail felt punching? = =3D If not, what do I use?" =20 Geoff, If there is enough left of a few, to ascertain the kind of felt and the original thicknes, you can make your own. Use Arch Punches to punch out = a set in the appropriate felt/thickness. You can get a set of Arch Punches = at Harbor Freight. However, you'd best sharpen them before using.<G> This = can be done on a piece of 120 grit sandpaper, if you don't have a vertical = belt sander. Regards, Joe Garrett, R.P.T. Captain, Tool Police Squares R I ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/6d/1a/7d/ad/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC