This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Hi John, I charged my unit overnight - it appeared to charge well - from full = discharge it was still charging after 1 hour and then 50 minutes later = when I checked it, it had completed a charge. I used the VT for about an hour this morning - I installed the latest = firmware (from 2003) and played around with that a bit to see the new = spinner, etc. One of the new features is the battery charge-state = monitor. I pushed the right arrow and kept getting an empty battery = simbol (no squares in it, which would indicate a high state of charge). = So I took the back off my VT to check battery charge-state and it is at = 13.03V - which I should think is A-OK for an older battery that was used = for a good hour or so (there are 10 1.2V cells, so it should really = only be 12V, but I suppose like a car battery, it is usually a bit more = when fully charged). But then why does my charge-state indicator suggest = the battery is dead? Hmmmm. I guess I'll just use it and see how long it lasts. Terry Farrell Hi Terry, Immediately after being unplugged from the charger. Unloaded = voltage 14.204VDC Unit on voltage 14.08VDC Hope this helps. John M. Ross Windsor, Nova Scotia, Canada jrpiano@win.eastlink.ca ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/35/66/51/ab/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC