This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Sarah asked: "QUESTION: Is this the sort of problem that will go away = by itself, as =3D the new dampers continue to seat? Or am I using the wrong wedges? Or = =3D perhaps I should "skinny down" the tips of these wedges by filing their = =3D inside surfaces with an emery board? Thanks for any advice! Sarah, I'd suggest the "damper pliers" from Renner. A trick is to heat them. = Use a coffee warmer or some other mild heat source. Give the tips of the = tri-chord dampers a "pinch". The hard part is getting each "tip" the = same as the others. Takes a little practice, but works well. Best Regards, Joe Garrett, R.P.T. Captain, Tool Police Squares R I ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/67/4a/4f/6e/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC