On Jan 18, 2005, at 5:16 PM, ROBERT MIHLFELD wrote: > Hi group, i am looking for suppliers of impact tuning hammers. Who > makes > them and which is best? Thanks in advance. We've recently (November 2004) started manufacturing our own design of Impact Tuning lever. We have 3 models. Our top model is mostly Titanium with a bronze weight. Here is the link: http://www.reyburn.com/cyberhammer.html I've been using an impact hammer for about 15 years of my 27 years tuning. If it weren't for this type of tuning tool I would not tune vertical pianos because of an old shoulder injury. But I've always had to modify the ones I purchased, and was still never satisfied with anyone else's design until we made our own. We are currently a bit behind on production, having a small two-mill shop we can't turn these out very fast. There is a lot of hand work in each one. There is about a 4 to 6 week waiting list for the Titanium models. Best regards, -Dean ^*^*^*^*^*^*^*^*^*^*^*^*^*^*^*^*^*^*^*^*^*^*^*^*^*^*^*^*^*^*^*^*^*^*^* Dean L. Reyburn, RPT RPS, Inc. dlr@reyburn.com 2695 Indian Lakes Road <http://www.reyburn.com> Cedar Springs, Michigan, 49319 USA Sales & support: 1-888-SOFT-440 (or 616-696-1002) Fax: 616-696-8121
This PTG archive page provided courtesy of Moy Piano Service, LLC