This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment _____ From: pianotech-bounces@ptg.org [mailto:pianotech-bounces@ptg.org] On Behalf Of Erwinspiano@aol.com Sent: December 29, 2005 1:30 PM To: pianotech@ptg.org Subject: Ungar heat gun Hey Guys & Dolls I though before I went out & purchased a new heat gun I'd see if any one has a good used one they like to part with. I use it primarily for heating shanks. Thanks Dale Part with an Unger heat gun? You're kidding, right? I demonstrated one of these -- a Princess model -- in the first class I ever did at a PTG Convention (1972, Portland, Oregon). The class was on grand hammer hanging and I was using it to demonstrate heating hammershanks. It was a carry-over from my Air Force days where I had used it to shrink Teflon tubing around soldered joints. As I recall no one in the class had ever seen one before but by the next year it had shown up in the Schaff or APSCO catalog (I don't remember which). Since then I've been through several but wouldn't dream of parting with the one I have now. Speaking of shrinkable Teflon tubing -- it's still the best fix I know of for sticky old Steinway butterfly springs. Del ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/b7/ff/0e/03/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC