This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment I use the plastic wire zip ties to tie one sticker to the guide rail in 3 to 4 places. It's easy, they're cheap, just cut them off when you are done. Dean Dean May cell 812.239.3359 PianoRebuilders.com 812.235.5272 Terre Haute IN 47802 -----Original Message----- From: pianotech-bounces@ptg.org [mailto:pianotech-bounces@ptg.org] On Behalf Of Alan Barnard Sent: Wednesday, August 03, 2005 9:32 PM To: Pianotech Subject: Re: howard spinet To quote the robot: "Warning, Mr. Smith, Warning." If this is the action Joe describes here DO NOT remove sticker wires from the guide bar or let them fall out-MAJOR pain to get them all back you, AMHIK. Do what he said, put damper blocks on several wires ABOVE the rail and tighten the screws. Alan Barnard Salem, Missouri ----- Original Message ----- From: Joe And Penny <mailto:imatunr@srvinet.com> Goss To: Pianotech <mailto:pianotech@ptg.org> Sent: 08/03/2005 9:02:16 PM Subject: Re: howard spinet Ohoh. Is this the one with the wood rail with the stickers comming up through it? If it is you need 4 or 5 damper heads drilled out to, I think it is 1/8 inch. You will capture the wire end of the sticker at the end of each section. This one is easy but still look for the brace. It may be a rod. Rough setting of lost motion can be done by adjusting the hight of the sticker rail. You will want to purchase a 12" long thin 1/8" screwdriver. Joe Goss RPT Mother Goose Tools imatunr@srvinet.com www.mothergoosetools.com ----- Original Message ----- From: richard.ucci@att.net To: pianotech@ptg.org Sent: Wednesday, August 03, 2005 7:06 PM Subject: howard spinet Hi Guys, Came across a baldwin howard spinet with jack flanges that are comming unglued. I want to pull the action, but it was designed in a way I have yet to see. Bolted to the plate-no struts, and these long flat metal pieces that are screwed into the wooden platform under the action. Anything I should be aware of other than the usual stuff? Also , will the pianotek sticker holder work on this model? Thanks, RU/UP ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/6e/0f/36/53/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC