This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Fwiw If you must make one of these levers - an 8 pt. socket is available in 1/4" drive and size. An 8pt. socket will fit with less chance of slipping on worn screws. CA or Epoxy (my preference) the whole assembly to insure rigidity. John Fortiner Billings, MT -----Original Message----- From: tom driscoll [mailto:tomtuner@comcast.net] Sent: Saturday, April 23, 2005 12:03 PM To: Pianotech Subject: Re: MH Screw Stringers-missing tool Try this , Home made Mason Hamlin tuning tool. (Refer to my screw stringer posting of Sept 5 2003) 1'4' drive -Sears T-handle,6"extension 1/4"deep 12 point socket wooden tool handle-(rosewood optional) CA 'D all components together - https://www.moypiano.com/ptg/pianotech.php/attachments/38/57/f6/91/P1010070.JPG Tom Driscoll rpt ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/34/ad/d6/5d/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC