micrometer source

[Cy Shuster]

Conrad,

I wondered about the vernier calipers; could you use them for all the
strings, or would you also need a micrometer?  Are calipers as accurate?

Signed,

--Cy Limited Tool Budget Shuster--
Bluefield, WV

----- Original Message ----- 
From: "Conrad Hoffsommer" <hoffsoco@martin.luther.edu>
To: "Pianotech" <pianotech@ptg.org>
Sent: Wednesday, September 29, 2004 5:19 AM
Subject: Re: micrometer source


> I use a simple 1" (Mitutoyo) micrometer for those where I can fit it.
> For those core wires, etc. which are too close together, I use a vernier
> caliper (also Mitutoyo). With it, I can even do all the core wires and
> plain wire in the pin area without bending over - the back _is_ getting
> older, you know... ;-}
>
> Conrad Hoffsommer
> You have the right to remain silent. Anything you say will be misquoted,
> then used against you.