This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment I've got a bit of problem/dilemma: Upright action with about a dozen = backcheck wires, broken below the surface of the wippen body! I drilled = one out with the hollow/reverse drill bit, that is used to extract = screws. This leaves a 1/4" hole, which can be filled with a dowel/glue. = However, I don't like the idea of re-drilling the pilot holes, for the = new wires, into end grain. I can drill a 7/32" hole across the wippen = plug, so that it would be in line with the new pilot hole and that would = give a more stable cross grain to drill/thread into.That is a lot of = drilling and plugging! Anyone have a better way to extract the olde wire stub, w/o all this = hassle?!!!??? Best Regards, Joe Garrett, R.P.T. Captain, Tool Police Squares R I ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/b1/d6/16/e7/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC