This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Are you Standard System literate? Are you Metric System literate? By answering the following question, you can determine objectively which is the right system for YOU: (I am assuming there is no right system for everyone!) "Standard" System: You have a # 12 size screw and you want to drill the clearance hole .020" larger than the screw shank. Which drill do you use? a) #1 size drill bit b) "A" size drill bit c) 15/64 " drill bit Metric System: You have a 5.5 mm screw and want to drill the clearance hole 0.2 mm larger than the screw shank. Which drill do you use? a) 57 mm drill bit b) 5.7 mm drill bit c) 5.3 mm drill bit Remember, no peeking in books, charts, and tables :^) Jurgen Goering ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/db/94/5d/25/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC