The thin clear coat epoxies flow out better than normal epoxies but still not great. Use a decent brush (which must be discarded afterward) to get the surface as smooth as possible. An orbital sander cleans it up pretty will. If you put on a satin finish or rub out the finish, rather than a high gloss, any irregularities will be less visible. David Love davidlovepianos@comcast.net -----Original Message----- From: pianotech-bounces@ptg.org [mailto:pianotech-bounces@ptg.org] On Behalf Of James Grebe Sent: Wednesday, October 20, 2004 2:56 PM To: Pianotech Subject: Re: Epoxy on soundboards How then, do you get an acceptable finish on something as visible as the soundboard if the epoxies does not flow out? James Grebe Piano-Forte Tuning & Repair Creator of Handsome Hardwood Caster Cups (314) 608-4137 WWW.JamesGrebe.com 1526 Raspberry Lane Arnold, MO 63010 BECOME WHAT YOU BELIEVE! pianoman@accessus.net ----- Original Message ----- From: "Ron Nossaman" <rnossaman@cox.net> To: "Pianotech" <pianotech@ptg.org> Sent: Wednesday, October 20, 2004 4:52 PM Subject: Re: Epoxy on soundboards > > >All the epoxie I have seen as a finish dries with little specks of dust in > >it. Can you keep the dust from settling in it long enough to harden so it > >is just a flat glossy film? > >James Grebe > > I sure can't, but then I don't think I've ever seen epoxy flow out that > flat anyway. > > Ron N > > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives > _______________________________________________ pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC