Not sure about this, but I think that 14.5 on the bridge is equivalent to 14 standard US size. Yes, I just checked with the micrometer and metric 15 1/2 is exactly .035" which is 15 standard. Marcel Carey, RPT Sherbrooke, QC Canada, > -----Original Message----- > From: pianotech-bounces@ptg.org [mailto:pianotech-bounces@ptg.org]On > Behalf Of pianolover 88 > Sent: October 16, 2004 8:14 PM > To: pianotech@ptg.org > Subject: yamaha wire is metric > > > Found out today that the wire size indications that Yamaha > stamps on their > grand piano bridges are METRIC, not standard sizes. I > confirmed this with > tech Greg at yamaha corp. When I mentioned this to a couple > other techs (who > have more experience than myself), their typical reaction > was, "hmmm, I > didn't know that". So, for example, 14.5 on the bridge > calls for 15 standard > size. How many on the list knows this? (Probably most > everyone but me! :)) > > Also, since I'm restringing my yamaha G1, after removing > the old understring > felt, i found that the "curved" piece at the beginning of > the plain wire > tenor section (between agraffe and tuning pins) is actually > a piece of > cardboard, covered with thin felt, instead of one thick > piece, as in the > last two sections. Upon further inspection, the underside > of the cardboard > also has an extra strip of the material on one side, and a > thinner strip of > felt on the other, for DB purposes no doubt. I wonder if > you can order these > pieces ready-made, or will i have to just make a "copy' of > it myself. > > > Terry Peterson > > _________________________________________________________________ > Check out Election 2004 for up-to-date election news, plus > voter tools and > more! http://special.msn.com/msn/election2004.armx > > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC