Thanks. I wondered about that, but the una corda does shift the action. I don't think the hammers move, too, but I'll look again. I guess it could have been a standard design feature, installed even in grands that didn't use it. --Cy-- ----- Original Message ----- From: "Ron Nossaman" <rnossaman@cox.net> To: "Pianotech" <pianotech@ptg.org> Sent: Saturday, October 16, 2004 11:13 AM Subject: Re: Pivoting hammer rest rail? > >>I worked on the action of a 1923 Ellington grand last week. The hammer >>rest rail was supported by brass rods at the action brackets, with felt >>bushings that allowed the rail to pivot upwards through roughly 90 >>degrees. What's that for (besides making it easier to access the >>wippens)? >> >>--Cy Shuster-- > > > That's the soft pedal. It was common in players, rather than an action > shift, and showed up in some other pianos that never had a player in them. > I had an old Bradbury grand with this kind of arrangement, with a lost > motion compensator built in to the wippen. > > Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC