It's there #319 Joe Goss RPT Mother Goose Tools imatunr@srvinet.com www.mothergoosetools.com ----- Original Message ----- From: "Farrell" <mfarrel2@tampabay.rr.com> To: "Pianotech" <pianotech@ptg.org> Sent: Thursday, October 07, 2004 12:23 PM Subject: Re: screw holders > Contact Joe Goss of Mother Goose Tools fame at imatunr@srvinet.com. He > sells a real slick screw-holding screwdriver that works quite well - > releases quite easily - but not too easy! I didn't see the tool on his web > site. > > Terry Farrell > > ----- Original Message ----- > From: "J Patrick Draine" <draine@comcast.net> > To: "Pianotech" <pianotech@ptg.org> > Sent: Thursday, October 07, 2004 1:42 PM > Subject: screw holders > > > > What are the rest of you doing for screw holders? The Schaff "rigid > > shaft screwholder" (#874) is next to useless for removing/replacing > > hammer flanges screws in vertical piano actions. My old ones which > > looks the same, from Apsco or Tuners Supply, worked fine, but I lost > > them (on some customer's floor no doubt). The current (unless they > > redesigned since I complained to a staffer at Nashville) Schaff version > > doesn't open wide enough to release the screw properly. Anyone buy one > > recently that is acceptable? > > How about other models at other suppliers that you're satisfied with?? > > Patrick Draine > > > > _______________________________________________ > > pianotech list info: https://www.moypiano.com/resources/#archives > > > > > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC