This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Terry, My preferred method is fairly old, but has proven good. Epoxy and Heavy Duty Soldering Iron. It's time consuming, but works well. Best Regards, Joe Garrett, R.P.T. Captain, Tool Police Squares R I Epoxy can be warmed with a heat gun or blow dryer, whatever, after you place it on the cracks. It becomes very thin and migrates into the cracks very well, but also sets quickly. Use some tape to build dams around the area, set the bridge pins where you want them, apply glue then heat. Allow 24 hours to cure. Paul C ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/cc/72/ac/8f/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC