---------------------- multipart/mixed attachment I made a string lifting tool to remove the natural curve at the v-bar: A spinet caster mounted on the end of a pin block scrap. It is levered on the key bed against a suitable block of the closest wood at hand. I lift the duplex side first, then the speaking length. For bass strings, I place a scrap of wood between the unison and the wheel; a segment of the Renner slats which come with their hammer sets is perfect. To remove the curve at the bridge pins I made "The Terminator" out of a screw driver (jpg attached). I also tap the wire at the rear and front duplex. Both sides. The loop at the hitch pin is coaxed with parallel pliers. Jon Page ---------------------- multipart/mixed attachment A non-text attachment was scrubbed... Name: Terminator.jpg Type: image/jpeg Size: 208990 bytes Desc: not available Url : https://www.moypiano.com/ptg/pianotech.php/attachments/f2/92/f2/c7/Terminator.jpg ---------------------- multipart/mixed attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC