I forgot to mention, You first cut off the old knuckle flush with a bandsaw leaving the old core in place. Maybe that was obvious. David Love davidlovepianos@earthlink.net > [Original Message] > From: David Love <davidlovepianos@earthlink.net> > To: Pianotech <pianotech@ptg.org> > Date: 5/20/2004 8:25:13 PM > Subject: Re: Relocating Knuckles > > Attached are two photos of a jig for routing out a new slot. It's made out > of the scrap of an underlever tray and a couple segments of those dividers > from Renner. Its designed to slide over a router holding a small end mill > corresponding to the width of the knuckle core. You can use it also with a > dremel table though you have to secure the dremel well enough that the > mount doesn't flex. More of a no brainer than the band saw technique. > > > David Love > davidlovepianos@earthlink.net >
This PTG archive page provided courtesy of Moy Piano Service, LLC