---------------------- multipart/alternative attachment Hi Bill If this was a 7/32nd thread then my preferred method of repair would be to tap the hole for 1/4" which is slightly larger & install a 1.4" new aggraffe. It makes servicing and repair more sure & reversabile if need be later. I am aware of JB welds strength. My guess is the whole thing could be extracted later ,although some what painfully ,drilled & retapped for the larger size. Just my 2 cents worth. Regards Dale I just ran into a massed up aggrafe in a s and s B. I roughed up the threads with a tap and die, and used JB Weld. It has 2 ton strength and can be drilled etc. They use it for engine block repairs. It is thick and easy to work with. It takes 14 hours to harden completely. Bill Peterson ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/37/d1/d0/04/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC