Hi Jon, > If it comes to raising the hammer centers/rail, shim the whole stack under > the brackets. Moving the hammer rail upwards won't do you any good. In fact it will only worsen the problem (slightly). Remember that the knuckles will *also* be relocated (upwards) in this process, so the jack will have to come up even higher -- by approximately the same amount that you are letting the wippen rise before the jack kicks out. If you don't believe this and insist on shimming the hammer rail, remember to check clearance between the drop screws and the pinblock. You don't want them to scrape/bind as you're sliding the action in and out. However, Ric is right. The most obvious fix is to sand the back-sides of the buttons, so that you can adjust them a bit higher. Peace, Sarah
This PTG archive page provided courtesy of Moy Piano Service, LLC