Yes yes yes... but what happens when the tails are too short ?? Hmmmm ??? :) Cheers RicB antares wrote: > > On 16-aug-04, at 22:51, Stephen Birkett wrote: > >> Antares wrote: >> >>> Hi Avery, there should be a 2 mm distance between the back check and >>> the hammer tail. That is the very very best back check position. >> >> >> Do you mean in the **vertical** direction, between the level of the >> bottom of hammer tail lowest point to level of the top of backcheck >> surface highest point? or do you mean **direct distance from one to >> t'other? > > > I mean that after the motion of drop, you should be able to stick a > 2mm stick between the tail of the hammer and the top of the back check. > > André oorebeek
This PTG archive page provided courtesy of Moy Piano Service, LLC