This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Hello Dale. I'm looking for a few more details describing your (or = anyone's) center-pin-anti-skid methods. I was planning on trying = something like that for my next board. I imagine the pins penetrate the = panel side of the rib maybe 4 to 8 millimeters (just enough to gain = solid footing) and penetrate the panel just a few millimeters (just = enough to hold in position) - is that correct? Do you taper your ribs = before gluing to panel - how do you handle running a pin through the = thinner ends of the rib? Do you just use two pins per rib (obviously on = short ribs) or do you maybe use three or more on the longer ribs? One other thought on glue cleanup - one thing that I was going to try to = implement - which relates to access for cleaning the glue joint = squeeze-out. Adjust the top beam of the pneumatic clamp so that the hose = can inflate most of its diameter (obviously maintaining full = contact/pressure on rib). If the hose is allowed to inflate a goodly = amount of its diameter, rather than allowing only a half-inch of its = diameter and blobbing over the sides of the rib, you should be able to = maximize access to the rib/panel joint for cleanup. Or at least I will = be trying that next time. Thanks. Terry Farrell ----- Original Message -----=20 From: Erwinspiano@aol.com=20 To: pianotech@ptg.org=20 Sent: Saturday, September 20, 2003 10:16 PM Subject: Glue cleanup on ribs Trix and I pressed up a S&S O board today. We tried using tight = bond again but tried to get a better feel for just the right amount of = glue to apply so that only a small amount of squezze came at the out = when we turned up the 40 P.S.I air pressure. It worked much better and = the samller amounts of glue were more easily cleaned up with damp rags = and dry paper towell. With only 11 ribs the spacing between cauls was = wider and 1& 1/2 hrs. This will probably continue to be our chosen = method. Also on a different subject ,on occasion we've had the ribs scoot = sideways as we apply pressure (this happened with go bars to) so we = install short center pins into the ribs glue surface to keep them from = skidding sideways when the pressures turned up. Dale Erwin Erwins Piano Restoration ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/bc/cf/f3/a2/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC