-----Original Message----- From: pianotech-bounces@ptg.org [mailto:pianotech-bounces@ptg.org]On Behalf Of Bill Ballard Sent: Sunday, August 31, 2003 1:44 PM To: Pianotech Subject: Re: Tuning pin bushings At 12:26 PM -0500 8/31/03, Richard Oliver Snelson wrote: >Put them in before spraying the >plate to avoid ruining the finish. (Better yet brush the walls of the >holes with the epoxy.) Better yet, glue the bushings in the plate holes (just before final assembly). Bill Ballard RPT The loose fitting bushings will split when a pin is diven through them. Been there, done that. Paul C
This PTG archive page provided courtesy of Moy Piano Service, LLC