on 5/22/03 7:17 PM, Michael Spalding at spalding48@earthlink.net wrote: > Is there a > tool I don't own yet, for adjusting let-off screws with low overhead > clearance? Nope. Those guys just didn't like technicians. I use 2 tools---a capstan "wrench," which is actually, like, a long pointy thing, kinda bent at one end, and a pair of Renner duck-bill pliers. > Or do I have to run another hammer rail over the router table? uh----whatever, dude. :--) David Andersen
This PTG archive page provided courtesy of Moy Piano Service, LLC