John: Look in your PTG Journal on CDs. Bill Spurlock did an article complete with detailed plans on how to build and use a blast cabinet. Beads are glass as I recall, cabinet is on wheels and can accept a complete large grand action. I have long wished to have one - just haven't found the time to make one yet. Dave Schwartz in St. Paul, MN had one in his shop when I was there a few years ago. Pretty impressive how it can clean up a scuzzy old piece of wood real quick. IMHO, especially for someone doing a lot of action work, one of these cabinets would be a real asset. Terry Farrell ----- Original Message ----- From: "John Ross" <jrpiano@win.eastlink.ca> To: "Pianotech" <pianotech@ptg.org> Sent: Thursday, July 17, 2003 6:06 PM Subject: Re: Keytop material? > Hi Stan, > I have heard of the bead blasting before. > What material are the beads made from, what is the size, and what pressure > do you use? > Do you have a cabinet made, if so what are the dimensions? > Thank you. > Regards, > John M. Ross > Windsor, Nova Scotia, Canada > jrpiano@win.eastlink.ca > ----- Original Message ----- > From: "Stan Kroeker" <stan@pianoexperts.mb.ca> > To: "Pianotech" <pianotech@ptg.org> > Sent: Thursday, July 17, 2003 6:47 PM > Subject: Re: Keytop material? > > > > Calin, > > > > I do alot of keytop replacement and have got the process down to between 4 > and > > 5 hours. I use the ubiquitous molded plastic keytops all the time and I > > believe the quality of the outcome is in all of the details, not just the > > keytop material. ie: edges trimmed flush to sides of keys, consistant > front > > overhangs (where tops only are used), consistant square notches (always > machine > > cut), keysticks milled to preserve original key height, all sharp edges > > softened (either with a file or by machine buffing), and finally, buffing > the > > new tops (they are always scratched right out of the box). On old sets, > > bead-blasting the keysticks is the icing on the cake - makes the set > look > > like new. Seems to me all new piano keys are plastic. > > > > Best regards, > > > > Stan Kroeker > > Registered Piano Technician > > > > Calin Tantareanu wrote: > > > > > Hello! > > > > > > I was wondering what material are you using for replacing keytops? > > > I tried some plastic molded ones and they look like... plastic. > > > Are there better alternatives? Something that doesn't have the plastic > look, > > > more like ivory. > > > What are the piano factories using nowadays? > > > > > > Calin Tantareanu > > > ---------------------------------------------------- > > > http://calintantareanu.tripod.com > > > ---------------------------------------------------- > > > > > > _______________________________________________ > > > pianotech list info: https://www.moypiano.com/resources/#archives > > > > _______________________________________________ > > pianotech list info: https://www.moypiano.com/resources/#archives > > > > > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC