This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment The titanium bits won't touch stainless steel. Cheap. They also dull up = too easy when they heat up. They don't last. The cobalt ones are only a = dollar more, maybe two. The end of a tuning hammer shaft snapped off in a one piece, extra tall = head. My cobalt bits went right through it. Unfortunately I still = couldn't get it to unscrew. Keith Roberts ----- Original Message -----=20 From: Tompiano@aol.com=20 To: pianotech@ptg.org=20 Sent: Wednesday, July 02, 2003 12:43 PM Subject: Re: Accu-just hitch pin removal Keith, Good tip about bit composites. I used a titanium bit ( steel use) it = didn't budge the material. Tom Servinsky=20 ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/b1/e0/10/6a/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC