Action Elevations

[David Love]

Ric B:

Just for the record, why would you have to choose (except in the situation
I mentioned)?  Under ordinary circumstances, you could simply bore the
hammers and adjust the rake so that the shank was parallel to the keybed
and the hammer was 90 degrees to the string, even if you had varying string
heights.  

David Love


> [Original Message]
> From: David Love <davidlovepianos@earthlink.net>
> To: PTG <pianotech@ptg.org>
> Date: 1/21/2003 8:12:38 PM
> Subject: RE: Action Elevations
>
>
> Ric B:
>
> I would choose hammer at 90 degrees to the string over the shank being
> parallel to the keybed.  In practice, the string is not actually parallel
> to the keybed.  It rises slightly as it moves toward the bridge.  Some
> techs (Richard Davenport comes to mind) advocate a slight short bore so
> that the hammer is at 90 degrees to the string at impact.  You could
> accomplish the same thing raking the hammer inward slightly.  
> Historically, this was sometimes done to accommodate shank deflection.  I
> have encountered older pianos (Bechsteins, for example) where the string
> heights were not only uneven, but were such that a bore of flange center
> pin to string height distance would not allow the bass hammers to get
> underneath the block.  In such cases I have bored all hammers the same and
> adjusted the rake in each section to accomplish the 90 degrees at impact. 
> It has produced no strange regulation compromises nor any compromise in
> feel that I could detect.  It seems that this is how the hammers were
> originally installed.  
>
> I'm not sure I understand your second question.
>
> David Love
>
> > [Original Message]
> > From: Richard Brekne <Richard.Brekne@grieg.uib.no>
> > To: PTG <pianotech@ptg.org>
> > Date: 1/20/2003 7:52:00 AM
> > Subject: Action Elevations
>
> ...snip...
>
> > So first... if you have to choose the lesser of two evils... what would
> > you say is the right choice to make ? Keeping the hammer shank
> > centerline parallel to the keybed at strike distance or hitting the
> > strings at 90 degrees ?
>
> ...snip...
>
> > Another question I am wondering about....
> >
> > If the center spread is to be viewed as a fixed value, and bore distance
> > is fixed..doesn't that sort of dictate the height of the hammer shank
and
> > whippen centers over the keybed ?
>
>
> > RicB
>
>
>
> _______________________________________________
> pianotech list info: https://www.moypiano.com/resources/#archives