Drying pinblock before stringing

[Mike McCoy]

Yeah yeah yeah..... Like I have nothing ELSE to do! But you're right, time to fire up the Torque-O-Meter again, right after the Convention in April, or maybe sooner. I should have put the info in Excel also so more people can use it.

 Nice to see someone can actually find it after all that time Ron! If you don't mind sending me the Excel file I'll just update that one. I think I used Lotus spreadsheet and I have graphs to go with it also but most of the world does not use Lotus products.

Mike

Mike McCoy RPT
Chapters 170 & 190 PTG
Langhorne, Pa
mailto:mjmccoyrpt@earthlink.net
----- Original Message ----- 
From: "Ken Jankura" <kenrpt@earthlink.net>
To: "Pianotech" <pianotech@ptg.org>
Sent: Friday, February 28, 2003 11:25 AM
Subject: Re: Drying pinblock before stringing


> That was one of our chapter technicals a few years back. It's probably time
> to take another reading. Mikey, you out there?
> Ken Jankura
> 
> ----- Original Message -----
> From: "Ron Nossaman" <RNossaman@cox.net>
> To: "Pianotech" <pianotech@ptg.org>
> Sent: Friday, February 28, 2003 10:57 AM
> Subject: Re: Drying pinblock before stringing
> 
> 
> >
> > >Which is probably why it usually takes years to be further damaged enough
> by
> > >EMC changes and pin forces to be noticed?
> >
> > I expect. Take another look at the data Mike McCoy posted Mar 8 2000 on a
> > chapter project to see what happens to torque ranges in different pinblock
> > materials with 2/0 pins in different hole diameters, over time. It's very
> > interesting. I have it in an Excel spreadsheet for a little easier viewing
> > if anyone's interested.
> >
> > Ron N
> >
> > _______________________________________________
> > pianotech list info: https://www.moypiano.com/resources/#archives
> >
> 
> _______________________________________________
> pianotech list info: https://www.moypiano.com/resources/#archives
>