I may be stupid or just really tired but I don't get it. I need more info ... you've only tweaked my interest. Alan Barnard Suspenseful in Salem, MO ----- Original Message ----- From: "Joe And Penny Goss" <imatunr@srvinet.com> To: "Pianotech" <pianotech@ptg.org> Sent: Saturday, September 28, 2002 9:05 PM Subject: Re: Mvc-020s.jpg > Hi Gordon, > This tool is used for final mating of string and hammer after the strings > have been leveled in a grand and the hammers reshaped.When doing work on an > upright I will try to mate the hammer to the string first by seating the > string with my brass seating rod and if that does not work I will use the > fitting block. Between the two one can eliminate a lot of wierd noise in the > low tenor notes of an upright. > Joe Goss > imatunr@srvinet.com > www.mothergoosetools.com > ----- Original Message ----- > From: "gordon stelter" <lclgcnp@yahoo.com> > To: "Pianotech" <pianotech@ptg.org> > Sent: Saturday, September 28, 2002 7:08 PM > Subject: Re: Mvc-020s.jpg > > > > What is this? Looks very elegant. > > Gordon Stelter > > > > --- Joe And Penny Goss <imatunr@srvinet.com> wrote: > > > Hi all, > > > Only open if you want to see the new design of the > > > fitting block. The new design is now on my web site > > > but is available in quanities now. > > > > > > Mvc-020s.jpg > > > > > > > > ATTACHMENT part 2 image/jpeg name=MVC-020S.JPG > > > _______________________________________________ > > > pianotech list info: > > > https://www.moypiano.com/resources/#archives > > > > > > > > > __________________________________________________ > > Do you Yahoo!? > > New DSL Internet Access from SBC & Yahoo! > > http://sbc.yahoo.com > > _______________________________________________ > > pianotech list info: https://www.moypiano.com/resources/#archives > > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC