This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment ----- Original Message -----=20 From: Rogerio Cunha=20 To: Pianotech Mensagem=20 Sent: Tuesday, September 24, 2002 3:38 PM Subject: HELP To the list After to use the Spurlock's Grand Hammer Tail Arcing Jig, the tail of = the hammer becomes very smooth and this makes difficult the backcheck. = There no difference if you use sandpaper 60 or 120 to do the arc. The = tail always is smooth. What is the best and easy way in order to scrape the tail? Thanks to all Rogerio Cunha IC Member of The Piano Technicians Guild Rio de Janeiro - Brasil http://planeta.terra.com.br/arte/dacapo/ http://www.perfectpitch.hpg.ig.com.br Rogerio It sounds to me that your sander is running too fast thus giving you = the smooth surface. If you can run it slow or even by hand, you can = re-sand the tails using the jig to hold them, and get them rough without = removing much material. Good luck Paul Chick ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/4c/bb/8c/4a/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC