Hello I just received an old Upright Rippen piano which for some time was subjeced to a very high degree of humidity. Most of the job is done alredy, but now it came to my attention that the pressure bar has lost pressure as some strings will just move freely sideways. I tried tightening it a little bit ( tuning is lower in excess of 150cts...) and it tightens easy, so I tried half turn per screw evenly across the whole pressure bar, Now when I strech strings stay in place. My question is, should I leave it there? Shall I tighten it further? How can I determine an optimal setting? or near it? Thank you
This PTG archive page provided courtesy of Moy Piano Service, LLC