---------------------- multipart/alternative attachment Sorry! That should have read screw up! At 05:37 PM 9/8/2002, you wrote: >Dale, > Only in the case of some screw that I was trying to correct. > >Greg > >At 02:38 AM 9/8/2002, you wrote: >>In a message dated 9/7/2002 7:09:15 PM Pacific Daylight Time, >>gnewell@ameritech.net writes: >> >> >>>Subj:Re: pulley keys - special tool from oliag (wood washers) >>>Date:9/7/2002 7:09:15 PM Pacific Daylight Time >>>From:<mailto:gnewell@ameritech.net>gnewell@ameritech.net >>>Reply-to:<mailto:pianotech@ptg.org>pianotech@ptg.org >>>To:<mailto:pianotech@ptg.org>pianotech@ptg.org >>>Sent from the Internet >>> >>> >>> Hi Greg >>> But why would you want to move the pin for or aft unless you plan on >>> moving the balance rail. Otherwise the front of the key would bind or >>> have a huge gaposis at the key slip. Just my thought. >>>Dale Erwin >> >> >>> >>>Newton, >>> Again, I beg your indulgence this once more. Does this system >>>(Onesti's) put back the pin hole exactly where it was before or do you have >>>the option to, say, center it more in the key stick or even move or fore or >>>aft if so desired? >>> >>>Greg Newell >Greg Newell >mailto:gnewell@ameritech.net Greg Newell mailto:gnewell@ameritech.net ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/9c/45/ff/96/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC