---------------------- multipart/alternative attachment Dale, Only in the case of some screw that I was trying to correct. Greg At 02:38 AM 9/8/2002, you wrote: >In a message dated 9/7/2002 7:09:15 PM Pacific Daylight Time, >gnewell@ameritech.net writes: > > >>Subj:Re: pulley keys - special tool from oliag (wood washers) >>Date:9/7/2002 7:09:15 PM Pacific Daylight Time >>From:<mailto:gnewell@ameritech.net>gnewell@ameritech.net >>Reply-to:<mailto:pianotech@ptg.org>pianotech@ptg.org >>To:<mailto:pianotech@ptg.org>pianotech@ptg.org >>Sent from the Internet >> >> >> Hi Greg >> But why would you want to move the pin for or aft unless you plan on >> moving the balance rail. Otherwise the front of the key would bind or >> have a huge gaposis at the key slip. Just my thought. >>Dale Erwin > > >> >>Newton, >> Again, I beg your indulgence this once more. Does this system >>(Onesti's) put back the pin hole exactly where it was before or do you have >>the option to, say, center it more in the key stick or even move or fore or >>aft if so desired? >> >>Greg Newell > Greg Newell mailto:gnewell@ameritech.net ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/c6/2e/56/a2/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC