New Steinway D problem

Baldwin Yamaha Piano Centre baldwin@mta-01.sk.sympatico.ca
Sat, 07 Sep 2002 16:07:58 -0600


---------------------- multipart/alternative attachment
At 09:24 PM 9/7/02 +0200, you wrote:
>jolly roger wrote:
>>Hi Ric,
>>              It's a tension bar, help prevent the two struts pulling 
>> apart.  The beams under the board also have tension struts.  That's 
>> those thinner slats that go cross ways.
>>Regards Roger
>>
>>

Hi Ric,
             You got me, on the Bell 'thingee', I have heard it called a 
treble resonator, or just the bell.  Yet I have never heard a real 
satisfactory explanation of what is going on.
On the tension bar thing.   A general rule of thumb;  If the bar is thin, 
it is usually associated with tension problems, if it is thick, then it is 
usually associated with compression. Not always true, but it helps to 
change your mind set of where the forces are heading.
  My feelings about both the tensioning rods, is that it was an after 
thought, to the original design. It being the most expedient method of 
giving some insurance to strength and stability.
  I have taken them off many times to work on, or replace the dampers at 
the break, with no disasters.
Regards Roger

>Thanks Roger... btw... what is the proper and most correct name for the 
>"bell" that couples the rim to the plate up in the treble section ?
>
>And thanks all you others for the good words of advice and caution.
>
>Cheers
>
>--
>Richard Brekne
>RPT, N.P.T.F.
>UiB, Bergen, Norway
><mailto:rbrekne@broadpark.no>mailto:rbrekne@broadpark.no
>http://home.broadpark.no/~rbrekne/ricmain.html
>

Roger

---------------------- multipart/alternative attachment
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/4b/94/da/1e/attachment.htm

---------------------- multipart/alternative attachment--


This PTG archive page provided courtesy of Moy Piano Service, LLC