Hi Phil, I would order 2 of a larger sheet, 5'X8', which would give 5,per sheet, plus some spare You would need 3 sheets of 4'X8'. It was a good point about the cheaper plywood having voids, which may have a loose bit, to vibrate. If you used ranger board, you would need veneer, if it wasn't black. Regards, John M. Ross Windsor, Nova Scotia. jrpiano@win.eastlink.ca ----- Original Message ----- From: "Philip Jamison" <mortier@netreach.net> To: <pianotech@ptg.org> Sent: Sunday, November 03, 2002 3:13 PM Subject: Knee Board Fabrication | I'm working on some studio pianos with missing knee boards. There are 7, all | mahogany Sohmer studios. They measure 18 3/4" X 52", so I'd get only one | per 4X8 sheet of plywood. Any suggestions? | | Philip Jamison | West Chester, PA | | _______________________________________________ | pianotech list info: https://www.moypiano.com/resources/#archives |
This PTG archive page provided courtesy of Moy Piano Service, LLC