If the pinblock already cracked, shimming or larger pins will make the crack worse. if the pinblock didn't crack,replacing with one or two size larger pins or dropping some thin CA glue works fine.I personally don't like shimming. > Is this why glue may be better? > To treat the loosed pins with CA glue takes less time,but the pin will be a little jumpy;to replace with larger pins takes longer time. Reaming the pin holes before insert the larger pin could result a smooth pin torch . > Is glue only useful for a cracked plank? Or also for > enlarged holes? Both. Baoli --- Scott & Jason Jackson <jurjens@tpg.com.au> wrote: > Won't shimming or larger pins make a crack spread > wider, making the problem > worse? > > Is this why glue may be better? > > Is glue only useful for a cracked plank? Or also for > enlarged holes? > > Scott > > > ----- Original Message ----- > From: "baoli liu" <baoli_liu@yahoo.com> > To: <pianotech@ptg.org> > Sent: Friday, 24 May 2002 6:09 > Subject: Re: Tunings stability problem > > > > Hi Ron, > > > > If you continue to find loosed tuning pins,you'd > > better check if pin block is cracking. > > > > Shimming with sandpaper is one way to kill loosed > > pins. replacing the original tuning pins with > larger > > ones or using CA glue also works well. > > > > Of course,pin block must be supported from > underneath > > while you replace pins or doing the shimming work > to > > prevent pinblock cracking. > > > > Baoli > > __________________________________________________ Do You Yahoo!? Yahoo! - Official partner of 2002 FIFA World Cup http://fifaworldcup.yahoo.com
This PTG archive page provided courtesy of Moy Piano Service, LLC