Gordon, Possibly Susan may be referring to a "Hammer Fitting Block". See http://www.mothergoosetools.com/tools/hammer_fitting.htm Scott ----- Original Message ----- From: "Gordon Holley" <gholley@hi-techhousing.com> To: <pianotech@ptg.org> Sent: Friday, 24 May 2002 6:07 Subject: Re: Old Packard upright > Hey Susan, I thought I had heard about all the ways to file (sand) > the hammers, but please help me on your suggestion of using a "hammer > file with the semicircular plastic sides" would this be shown in the > Schaff catelog or is this a shop made hammer file?. And yes I did > consider pulling the action and taking it home and putting it in my > action cradle and do the work there. And I hadn't thought about > leaving the bridal straps alone, especially if the springs are all in > place and working okay. > Again, thanks, and BTW are you a pianist. I am a pianist, have a > seven piece band and write (calligraphy ink pen on manuscript paper) > all the arrangements, over 600 in the past 11 years, swing, jazz, > rock and Latin. Regards, Gordon
This PTG archive page provided courtesy of Moy Piano Service, LLC