Potter Press. Randy Potter of Randy Potter School of Piano Technology. There should be a link on the PTG web site, or look in the PTG Journal - he has several ads. Terry Farrell ----- Original Message ----- From: "Greg Casper" <gcasper@pacbell.net> To: <pianotech@ptg.org> Sent: Thursday, May 23, 2002 8:16 PM Subject: RE: More uses for "G" Piano Works(barely) Labor Guide > From whom can the G Piano Guide be acquired? > > Greg Casper > San Jose, CA > -----Original Message----- > From: owner-pianotech@ptg.org [mailto:owner-pianotech@ptg.org]On Behalf Of > Clyde Hollinger > Sent: Thursday, May 23, 2002 4:44 PM > To: pianotech@ptg.org > Subject: Re: More uses for "G" Piano Works(barely) Labor Guide > > > Dave, > You've got a lot of courage! <G> If you run into the same situation > again in the future, you can stick to your guns but suggest they get a > second opinion. "That'll be a $xx consultation fee (unless you want to talk > with me longer)." > > But yeah, you do run into situations. About a month ago I saw a totally > shot upright, not serviced in more than fifty years. I declined to touch > it, and they accepted that, but the little grandma will keep playing it just > the way it is. They're not going to get anything else. I still think about > that, sometimes wondering if I made the right decision. > > Regards, Clyde > > PNHISTIC1@AOL.COM wrote: > > List, > Two days ago, I encountered one of those pianos that makes you want to > back out of the door as soon as you get in the house. Other than being > brought into the world as a Krakauer, there were virtually no redeeming > qualities: 7 broken shanks, not a single un-rotted bridle strap, barely a > bushing left in a key, flat hammers, rusty pins and strings, a hefty coating > of dust throughout, etc., etc... > > I tried my hardest to beg off, realizing that nothing less than a > complete rebuild would be satisfactory. But they wouldn't hear of it. The > gentleman asked me to fix the hammers, get it running so that he could play > it. I explained that without major repairs, it would never work to anyone's > satisfaction, that the shanks were probably cedar and would continue to > break. Again, they gently insisted that I fix the hammers. > > Two hours and several replaced and sleeved shanks later, I had > "completed" the job. I never got to tune it--which is just as well, > considering the condition of the strings and pins--but had spent substantial > time on the monster. > > The "G" Piano Works Guide was very useful for quantifying the job I had > done in a way that my customer could understand. I was able to make enough > money that it wasn't a total waste, and I gained some valuable experience. > I recommend carrying this useful guide in your kit or your car. > > Thanks to Joe and everyone else who put hours into creating this! > > Dave Stahl > >
This PTG archive page provided courtesy of Moy Piano Service, LLC