Ratchet tie down straps are easily capable for the lifting required and they can be fairly easily thread under the plate struts for positioning anywhere you like. They are also a heck of a lot less likely to do any damage. Greg Newell At 09:18 PM 5/13/2002, you wrote: >What do y'all use for plate lifting straps? I'm installing a chain hoist, >retiring an old and unwieldy gantry, and am not sure what the best straps >are. I was actually thinking about using rachet tie downs cause they are >adjustable in length but I'm not sure if they would hold under vertical >lifting. Any thoughts? > >I tried the archive and found that Ed Foote likes rope and a 'taut line >hitch' (did I get that right?) which I dont know if I trust myself to tie.... > >As always, thanks in advance..... Greg Newell mailto:gnewell@ameritech.net
This PTG archive page provided courtesy of Moy Piano Service, LLC