Hi Joe, A slight variation of your theme. I use the appropriate bit in a Tee wrench, and hand ream them. One respected local tech, has mentioned that I repin a little on the tight side, compared to the new blocks, that have been drilled in the drill press. New blocks, I use the same technique as Ron. (double drilling)Second cut is removing about .020". regards Roger At 12:06 PM 5/12/02 -0700, you wrote: >I used to use the gun bore brushes, but found them to be inconsistant. I >prefer to use the drill bit, appropriate for that size pin, (as if it were a >new block). I just chuck the drill bit in a slow RPM 1/2" (godzilla type) >hand drill and ream away. This has proven to be more controllable, for me. >Regards, >Joe Garrett, RPT, (Oregon) > > Roger Jolly Balwin Yamaha Piano Centres. Saskatoon/Regina. Canada.
This PTG archive page provided courtesy of Moy Piano Service, LLC