Hi, Hazen, I used a single hoist when I first started removing plates, but always felt out of control. I soon added a second one and now use three, one at each front corner and one at the back. There is no fussing with leveling, and in fact as someone said sometimes it helps to tip one corner up or down which you can do and then relevel. You do a little more walking from one hoist to another, but the plate is never trying to rotate on you, and each hoist need only be a simple rope type--$25-30. To protect the rim on removal I adopted an idea of I believe Susan Graham's: get several pieces of 6" roof flashing about 3'long and glue felt or heavy fabric to one side of each piece. Stand them on edge around the rim between it and the plate, soft side facing the rim of course. For reinstalling the plate they don't work so well, but for that I use pieces of cheap leather. APSCO sells it as "packing leather," #451420 on p. 118. You might find something similar at Tandy's. Nothing is handier around the shop for all sorts of case protecting uses and it's much tougher than old towels, etc. I rarely damage a rim and when I do I was usually in a hurry or being dumb. Best to all, Les Conover --- HazenBannister@cs.com wrote: > Hi list, > I wonder what is the best way,not only to remove a > plate (in a grand), but > to put it back in, in a finished cabinet,and > finished plate,safely.I have a > chainfall,and usually hook the wide moving straps > around it,but it never > comes out level. > Thanks, > Hazen Bannister > __________________________________________________ Do You Yahoo!? Yahoo! Greetings - send holiday greetings for Easter, Passover http://greetings.yahoo.com/
This PTG archive page provided courtesy of Moy Piano Service, LLC