Thanks for informion. Stéphane. ----- Original Message ----- From: "Delwin D Fandrich" <pianobuilders@olynet.com> To: <pianotech@ptg.org> Sent: Friday, March 01, 2002 7:56 PM Subject: Re: Chines and multi-piece rims > > ----- Original Message ----- > From: "Stéphane Collin" <collin.s@skynet.be> > To: <pianotech@ptg.org> > Sent: March 01, 2002 7:44 AM > Subject: Re: Bechstein Date > > > > Hi John. > > > > Sorry for my english, which is less than perfect. > > Nor is mine--and it's my only one.... > > > > > > How would you call a rim made not of one continuous bended multi-layer > piece > > of wood (as in modern pianos), but one made in three parts, making an > angle > > at each junction ? > > I'm not sure if there is an official name for these. We simply call them > two-piece or three-piece rims depending on how many separate sections are > used. > > > > > > I understood that Terry calls a chine that junction making an angle > between > > two adjascent parts of the rim. > > That is because Terry knows a thing or two about boat building. The squared > edge of a boat hull is called a chine. It is as good a name as any. > > > > > > Some Bechstein pianos, from after 1900 or so, have two of them, and the > > older ones have three of them. The modern Bechstein piano has none. > > They are not quite out of fashion yet. Our new 200 cm grand will have two > chines. The bass and treble sides are straight and there is one bent side. > > Regards, > > Del > >
This PTG archive page provided courtesy of Moy Piano Service, LLC