This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment ----- Original Message -----=20 From: Allan L. Gilreath, RPT=20 To: pianotech@ptg.org=20 Sent: January 17, 2002 5:03 PM Subject: RE: Baldwin accu-hitch pins David, Contact Stacy Yoak in Baldwin Tech service. stacy.yoak@bpao.com or=20 (877) 889-4805 - I believe they have a procedure sheet on this. I'm = sure I have a copy somewhere around here but it's not scanned or at = hand. To answer your other questions: Yes, each string is measured. = Not to my knowledge. No. Yes. If you can't reach him, let me know and I'll see if I can find that. There used to be a tool for loan as well. It was a simple punch with a = hole bored in one end that fit over the hitch. It was steel but fit = flush to the string and caused no damage.=20 Actually it is not necessary to measure each string. I certainly = don't. The first and last of each section and two or three through the = middle. Even them out in between. Del ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/21/b2/7a/8f/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC